2018 ICC M1 Residential Mechanical Inspector Exam Quiz

Self-contained refrigeration systems containing __________ or less of refrigerant do not require a permit.

Strapping of appliances in seismic areas must be designed so that the strapping at the lower point maintains a minimum distance of __________ above the controls.

In vented floor furnaces, the furnace register must be located a min. of __________ from doors in any position, draperies or similar combustible objects.

Piping for a secondary drain or auxiliary drain pan required for a cooling or evaporator coil, must maintain a min. horizontal slope in the direction of discharge a min. of __________ .

Clothes dryer exhaust ducts must not be joined with screws that protrude more than __________ into the inside of the duct.

Metal ducts in underground duct systems must be protected from corrosion in an approved manner or must be completely encased in concrete a min. of __________ thick.

Return air openings for heating, ventilation and air conditioning systems must be located a min. of __________ from an open combustion chamber or draft hood of another appliance in the same room or space.

The horizontal run of an uninsulated connector to a natural draft chimney must not exceed what percentage of the height of the vertical portion of the chimney above the connector?

Unless otherwise specified, gas piping systems installed underground must be at least __________ inches below grade.

In garages, appliances that have an ignition source must be elevated such that the source of ignition is not less than __________ above the floor.

Exhaust systems capable of exhausting more than __________ must be mechanically or passively provided with makeup air at a rate approximately equal to the exhaust air rate.

Condensate piping from cooling coils and evaporators must maintain a minimum horizontal slope __________ in the direction of discharge.

Clothes dryer exhaust ducts must be supported at max. intervals of __________ .

Gas-fired appliances must be provided with combustion air that complies with __________ .

Natural draft gas vents serving wall furnaces must terminate at a min. elevation of __________ above the bottom of the furnace.

Freestanding or built-in ranges must have a min. vertical clearance above the cooking top of __________ to unprotected combustible material.

Hydronic piping systems must be tested hydrostatically at a pressure of 1 1/2 times the maximum system design pressure, but not less than 100 psi for a min. duration of __________.

Supply piping used in the installation of oil burners and appliances must be a min. of __________ pipe.

What is the max input rating of an unvented room heater?

Vents for natural draft gas vents serving wall furnaces must terminate at a min. elevation of __________ above the bottom of the furnace.