531 South Dakota Journeyman Electrician Exam Welcome to your 531 South Dakota Journeyman Electrician Exam Name Email 1. When calculating the general lighting load for a dwelling unit, what is the required unit load per square foot? 1.5 Volt-Amperes (VA) 2.0 Volt-Amperes (VA) 3.0 Volt-Amperes (VA) 5.0 Volt-Amperes (VA) None 2. When installing a surface-mounted, completely enclosed incandescent luminaire in a clothes closet, what is the minimum clearance required between the luminaire and the nearest point of the storage space? 6 inches 12 inches 18 inches 24 inches None 3. In a dwelling unit bathroom, at least one receptacle outlet must be installed within how far of the outside edge of each sink basin? 18 inches 24 inches 36 inches (3 feet) 48 inches (4 feet) None 4. In a dwelling unit bedroom, receptacles must be installed so that no point measured horizontally along the floor line in any wall space is more than how far from a receptacle outlet? 4 feet 6 feet 8 feet 12 feet None 5. What is the minimum burial depth required for a direct-buried residential Type UF cable (rated 120V) that is not protected by a GFCI? 12 inches 18 inches 24 inches 30 inches None 6. When connecting a grounding electrode conductor (GEC) to a concrete-encased electrode (Ufer ground), the GEC is not required to be larger than what size copper wire? 8 AWG 6 AWG 4 AWG 2 AWG None 7. What is the required free space volume allowance for a single 14 AWG conductor in a junction box? 1.50 cubic inches 2.00 cubic inches 2.25 cubic inches 2.50 cubic inches None 8. When replacing an existing non-grounding type (two-prong) receptacle where no equipment grounding conductor exists in the box, which of the following is permitted? Replacing it with a standard three-prong receptacle and leaving the ground screw disconnected Replacing it with a GFCI receptacle marked "No Equipment Ground" Running a green jumper wire to the neutral terminal It must only be replaced with another non-grounding type receptacle None 9. At a permanently installed swimming pool, at least one 125-volt, 15- or 20-ampere receptacle must be located not less than how far from the inside wall of the pool? 3 feet 5 feet 6 feet 10 feet None 10. What is the minimum size copper equipment grounding conductor (EGC) required for a circuit protected by a 20-ampere circuit breaker? 14 AWG 12 AWG 10 AWG 8 AWG None 11. Which of the following is a standard ampere rating for an inverse time circuit breaker? 35 Amperes 55 Amperes 65 Amperes 75 Amperes None 12. What is the minimum required overhead clearance for service-drop conductors passing over a public street, alley, or parking area subject to truck traffic? 12 feet 15 feet 18 feet 20 feet None 13. When exactly two conductors are installed in a conduit, what is the maximum allowable percentage of conduit fill? 31% 40% 53% 60% None 14. For a dwelling unit, what is the minimum required clearance for overhead service-drop conductors (not exceeding 1,000 volts) passing above a residential driveway? 10 feet 12 feet 15 feet 18 feet None 15. What is the minimum size copper conductor permitted for general wiring up to 2000 volts? 16 AWG 14 AWG 12 AWG 10 AWG None 16. Nonmetallic-sheathed cable (Type NM) must be secured in place at intervals not exceeding: 3 feet 4.5 feet 5 feet 6 feet None 17. What is the minimum required length for a driven ground rod? 6 feet 8 feet 10 feet 12 feet None 18. The minimum clear width of the working space in front of electrical equipment must be the width of the equipment or a minimum of: 24 inches 30 inches 36 inches 48 inches None 19. Branch circuit conductors supplying a single continuous-duty motor must have an ampacity of not less than what percentage of the motor’s full-load current rating? 80% 100% 125% 150% None 20. What is the ampacity of a 10 AWG THHN copper conductor before any derating factors are applied? (Assume a 90°C rating) 30 Amperes 35 Amperes 40 Amperes 45 Amperes None Prove you are human Time is Up!